[mn pete]

It’s almost here! It’s like waiting for Christmas…kinda…without the reindeer and the snickerdoodles.

http://secondwindworkshop.blogspot.com/2013/11/getting-ready-for-woodworking-show.html

Anyone going to the Denver show? Have you gone to any of the earlier shows…Dallas, Portland, CA? The last show was the best I’d been too in the last few years. How’re they looking this year?

 

[TaleSspin]

A WW show in Denver? All I can say is be prepared for the beetle kill pine!

 

[mn pete]

Hopefully! The hardwood vendor did not attend the last show. I'm headed out to the show in just a while and will meet up with some woodworkers I've only met online so far.

 

[Burb]

I'm anxiously await for the Kansas City one Feb 28th.

Mark

 

[CPNMike]

Yep, I went today and going back tomorrow. I was going to buy a GRR Ripper2 there for $75 but then I saw the Rockler coupon for 20% off one item so I think I can do better at Rockler.

 

[mn pete]

Hey Mike, did you sit in on any of the seminars? I focused on Jim Heavey and Andy Chidwick's presentations. Both were really good. I noticed that the show is smaller than it was back in February. I was looking forward to the open turning area, but it wasn't included this year. I was hoping to get some hands on at the lathe.