Woodworking Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hello,

Apologies if this has been posted before. Can you offer advice. I need to engrave my wooden carved jewellery.

I have an electric wood carving set, however the heads are too thick, and the speed of the carver is not fast enough to make the lettering nice.

I have seen this product demoed on YouTube - ParaGraver 300 (fourth generation) and it is sold by www.profitablehobbies.com

It looks impressive, but they only ship in the USA. I need one that can be shipped to Ireland.

Is there anything like this you can make me aware of?

Thanks a million for your time.
 

·
Registered
Joined
·
1,885 Posts
Have you considered using a Dremel with a very narrow cutter? Those work for me, but are not made for real fine work. Be safe.
 

·
Registered
Joined
·
1,151 Posts
I have an engraver made by Dremmel that I've used for wood. It's just a vibrating point. If you're a carver I'm sure you could make it work.
 
1 - 3 of 3 Posts
Top