Woodworking Talk banner
1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Has anyone had experience using a Wixey Gauge? I bought one and it worked great setting the blade to table settings in my Miter Saw, but I can't get it to work setting the blade to the fence. Any suggestions?
 

·
Registered
Joined
·
17 Posts
Wixey

Brent ~ Can you give a little more detail? As long as the gauge is zero'd on one surface and the magnets are in intimate contact with the other surface I don't see why it wouldn't work.

~ Peter
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #4 ·
Thanks for your inputs guys. Clutchcargo was right on with his answer. I just got an e-mail from barry Wixey telling me the gauge won't work on that plane, but Wixey is working on a gauge that will work on that plane.
 

·
Registered
Joined
·
17 Posts
Misread

After reading Clutch's reply I looked at yours again and realized that I had mis-read it. I thought that you asked about setting fence to table... sorry about that.

~ Peter
 

·
Registered
Joined
·
17 Posts
mis-read

After reading Clutchcargo's response I re-read your original post and realized that I had mis-read your question. I was thinking fence to table.

sorry about that ~ Peter
 
1 - 7 of 7 Posts
Top