Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
175 Posts
I suppose you could start with something like this:
http://www.veneersupplies.com/products/AAA-Walnut-Burl-Veneer-Sheet--1075-x-1725.html

Then sand it down to whatever thickness you think will suit what you are doing (though 1/42 is pretty thin!) and then treat it accordingly. That's honestly about all I can think of. Producing materials as thin as you are looking for is very difficult to produce in a home shop. It could probably be done, but I think buying a veneer would be easier and the cost isn't horrible.

Let's see what other suggest.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top