Woodworking Talk banner
1 - 5 of 5 Posts

·
Registered
Joined
·
13,542 Posts
Really cannot tell from your picture. It looks like the white material is a border around the entire surface. Does it look like a solid material or could it the something squeezed out at the joint?

George
 

·
bzguy
Joined
·
581 Posts
PVC edge-banding in also applied with hot glue adhesive using Holtzer, etc., edge-banding machines, but that is usually flat.
This appears to have a slightly convex surface like T-molding.
If it was T-molding you can pry it away from an edge and it will return to it's shape.
The T-spline would have had to be notched to go around the small radii on the corners.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top