Woodworking Talk banner
1 - 1 of 11 Posts

· Registered
2,980 Posts
Are the feed tables really clean?
If you can, get the edge of each plane blade pointing upwards.
Inspect with a very bright light. If the blades are sharp you should see nothing.
If the blades have hit sand grains, etc, there will be a little bent over/crumpled bit of edge.
That flat spot will reflect a real "spark" of light.
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.