Woodworking Talk banner
1 - 1 of 1 Posts

Old School
24,017 Posts
I'm new to all this but I have researched a bit about it and plan to finish my burr veneer in this way;

Seal with diluted shellac (french polish/mentholated spirit 50/50)
pack pours (fine burr dust/pva)
Sand and wipe with meths to remove dust
Seal with Shellac
Apply 10 or so coats of internal brushing lacquer sanding every 2nd coat with fine sandpaper

Is this process going to be OK or are there any pitfalls using this sequence??
If you user shellac, use a de-waxed product like Seal Coat.

What do you mean "pack pours (fine burr dust/pva)"?

What do you mean "meths"?

1 - 1 of 1 Posts