Woodworking Talk banner
1 - 3 of 3 Posts

71 Posts
Discussion Starter · #1 ·
I just finished up installing my vega pro 40 fence on my craftsman 113.27520 table saw and I'm liking it.

The saw didn't have a fence on it when I bought it so obviously this is a night and day difference!

Slides nice, the cuts are parallel and it installed easily.

My only hitch which wasn't too bad was that my old saw didn't have any holes on the back of it. I had to drill both of them. No real biggie though.

I'll try to get some pics tomorrow, I was too lazy to come in, get the camera and go back out to the garage etc..

Two thumbs up so far on the fence.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.