Woodworking Talk banner
1 - 2 of 2 Posts

·
Senior Member
Joined
·
7,222 Posts
Wood may be kiln dried,,air dried or green. Kiln dry should have lower moisture content than air dry which should have lower moisture content than green.

Green wood is normally recently felled, or has not been allowed to dry due to sealing the ends, etc.

Green wood has two types of moisture - free and bound. A given species may contain more or less free moisture.

The free moisture is between the cells and will fly all over the place as you turn.

The bound moisture is within the cells and this takes time to dry.

Any time the moisture content of the wood is different than the surroundings, the wood will want to loose or gain moisture. For most people the wood is higher in moisture than the surroundings, so the wood looses moisture.

If you have a moisture meter, measure the wood when received.

If you do not have a moisture meter and are concerned about the wood moving as it dries, cut off a piece and weigh the item. Note the weight. Every week take another weight reading. If the piece is loosing weight, it is still drying.

If you turn a piece to finished shape and dimension and it looses moisture, you have the risk of warping, cracking, generally changing the shape.

Most people rough turn green wood. Set the piece aside for weeks or months and then when it has reached equilibrium they turn to final shape and dimensions.

One method to accelerate drying is soaking the piece in alcohol, often called DNA (DeNatured Alcohol). Here is one article by David R Smith on this topic.

http://alcoholsoaking.blogspot.com/
 

·
Senior Member
Joined
·
7,222 Posts
Wow, Dave! Good summary. Save that response to use again.

Since Dave's fingers got tired I'll throw in the microwave technique which can have pretty good success if you are careful. There are many variations of this technique so I'd advise searching for and reading a few threads about it before trying it.
Thanks trying to cover most of the bases. :thumbsup:

I was pondering about microwave drying, but since I almost burned up my microwave with my first experiment I decided to leave this alone.

A recent meeting of the local woodturners club had a bowl which looked great on the outside and for most of the inside, but at the bottom was a burned spot.

The person had been drying in the microwave, and forgot that microwave heats from the inside out, so he burned the inside. He smelled something burning, but did not seen any damage, until he turned the bowl and exposed the burnt spot.

Microwave drying can work, but you need to be careful. Only heat for short periods of time, as in a few seconds. Then let rest for e.g., a minute and repeat.

Look on the internet for more information and as Bonanza35 said - try this on an inexpensive piece first. A piece which you are willing to convert to scrap. :icon_smile:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top