Woodworking Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Is it possible to cut crown molding along the long side of the attached window (crown goes to the ceiling), then miter another crown molding piece on the vertical side? Horizontal run would be a ledge. The rest of the wall would be recessed panel to make up for the crown molding. Much appreciated!
 

Attachments

·
Registered
Joined
·
303 Posts
Crown molding is meant to go along the intersection of walls and ceilings. I don't get what you want to do when you say, "on the vertical side". You don't have an adjacent ceiling or wall on that side.

Also, it doesn't look like you have room for a very big crown above the window casing to the ceiling.
 

·
Registered
Joined
·
26,886 Posts
It looks to me like the window is too close to the ceiling for crown molding. Even if you managed to cut the trim down I think it would look bad to have the crown right against the window casing.
 
1 - 3 of 3 Posts
Top