Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
29,047 Posts
I have a joint I used Titebond II on and realized afterwards that the fit wasn't tight. The joint came apart. It is my understanding that wood glue soaks in deep and thus you can't use it to re-glue the joint. Does anyone have any experience with using epoxy with a filler in a situation such as this? Any other recommendations?
You are correct in that epoxy is better for a reglue however it would be better if there was something you could do to make the joint fit better before you reglue it.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top