Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
13,742 Posts
I would first make absolutely sure the blade is 100% square with the miter slot.

I had those problems also, and when I installed my incra fence, I went through the whole realignment regiment starting with the blade and following thru and ending with the fence. No more marks.
You mean parallel, not square.

George
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top