Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
336 Posts
I would first make absolutely sure the blade is 100% square with the miter slot.

I had those problems also, and when I installed my incra fence, I went through the whole realignment regiment starting with the blade and following thru and ending with the fence. No more marks.
 

·
Registered
Joined
·
336 Posts
You mean parallel, not square.

George
Square.

yes. it has to be 100% inline with the miter slot.

When checking the blade for square to miter slot, I use my Incra 1000se, which I check to be square to the miter, then using the same square i used for the 1000, I check the blade. worked for me.

To others looking on. Am I wrong in doing this??/
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top