Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I've been thoroughly frustrated trying to align my fence on a Bridgewood contractor's tablesaw. I have used a TS Aligner in the miter slot and tried to fine tune with the adjustment screws located on the fence but to no avail. Always 10 degrees variance at minumum. Both sides of the fence are off. Do I need a new fence? Are there alternatives? Am I forgetting something?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top