Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My old Craftsman flex shaft drive table saw (113.241680) has developed a problem. The blade drifts down as I cut. It is worse with a dado blade. I have looked all over the saw and all over the exploded parts diagram, but can't find any adjustment to tighten this up so the blade height stays put. Any ideas?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top