Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My old Craftsman flex shaft drive table saw (113.241680) has developed a problem. The blade drifts down as I cut. It is worse with a dado blade. I have looked all over the saw and all over the exploded parts diagram, but can't find any adjustment to tighten this up so the blade height stays put. Any ideas?
 

·
Registered
Joined
·
470 Posts
My old Craftsman flex shaft drive table saw (113.241680) has developed a problem. The blade drifts down as I cut. It is worse with a dado blade. I have looked all over the saw and all over the exploded parts diagram, but can't find any adjustment to tighten this up so the blade height stays put. Any ideas?
Try always making the height adjustment on the increase and never the decrease and see if the problem goes away.
 
1 - 2 of 2 Posts
Top