Joined
·
1,973 Posts
that looks like a neat table. you might consider building in a little lip and getting a piece of glass to fit in the top to protect it and keep small items from falling into the cracks.
If I were to try to make it, i'd make a couple of round pieces out of 2x6 material doubled up at right angles to each other and glue the outside sticks to those. sort of like this:
I think that would give the frame enough surface area for the glue to hold. IU'd space them about 6-8" from the top and bottom. Then I'd fill it in above and below with sticks and glue them in place as I went.
I would leave a couple of outside pieces off until the end to help get the last few filler pieces in place. Then I'd put the last ones on to finish it up.
If I were to try to make it, i'd make a couple of round pieces out of 2x6 material doubled up at right angles to each other and glue the outside sticks to those. sort of like this:
I think that would give the frame enough surface area for the glue to hold. IU'd space them about 6-8" from the top and bottom. Then I'd fill it in above and below with sticks and glue them in place as I went.
I would leave a couple of outside pieces off until the end to help get the last few filler pieces in place. Then I'd put the last ones on to finish it up.
