Woodworking Talk banner
1 - 1 of 1 Posts

Senior Member
7,222 Posts
+1 with Cabinetman on using some other straight piece as a guide for the table saw.

If you do not want to attach with finish nails, use double sided tape. I have the wood turners double sided tape. This hold very well.

These days I will also attempt to straighten one edge of a rough lumber piece with my #5 jack plane. I can get close enough so this edge is used against the fence. Straighten the other edge then flip to finish the first edge.

Using a hand plane needs the board to be clamped with the edge up. May not be so easy for you.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.