Woodworking Talk banner

1 - 19 of 19 Posts

·
Registered
Joined
·
266 Posts
Discussion Starter · #1 · (Edited)
SMOKING DEALS on Steel City Tools

Woodworker's Supply has smokin deals on the following:

Steel City Tool Works
35623 10" Deluxe Table Saw w/ 50" Industrial Fence - $1,199.99
35690 10" Deluxe Table Saw w/30" Industrial Fence - $1,149.99
35630 10" Titanium Deluxe Table Saw w/50" Industrial Fence - $1,349.99
35700 10" Titanium Deluxe Table Saw w/30" Industrial Fence - $1,299.99
40600 6" Industrial Parallelogram Jointer - $699.99
55210 16" x 32" Drum Sander - $699.99
65100 1-Speed Air Cleaner - $199.99
35626 10" Industrial Table Saw - $1,799.99

Go to www.woodworker.com
 

·
Registered
Joined
·
4 Posts
steel city band saw

I obtained a steel city model 20250 band saw that does not have a motor run capacitor in it. Does anybody have one that could give me the specs for the capacitor?

Thanks
 

·
where's my table saw?
Joined
·
29,002 Posts
dead thread revived

stop> read the date> thread is 11 years old> nothing is current!
Do not respond!
 
  • Like
Reactions: firehawkmph

·
Generic Weeb
Joined
·
1,039 Posts
The way I see it the post was revived in hopes of getting a capacitor number off a motor on an existing tool, hopefully someone has that saw and can give some useful advice.

Thing is the OP probably should have made a new thread instead of bringing this one back.
 
  • Like
Reactions: woodnthings

·
Registered
Joined
·
3,283 Posts
I obtained a steel city model 20250 band saw that does not have a motor run capacitor in it. Does anybody have one that could give me the specs for the capacitor?

Thanks
can you provide the information off the motor nameplate?


relax guys, it is his first post...
 

·
Registered
Joined
·
27,110 Posts
I obtained a steel city model 20250 band saw that does not have a motor run capacitor in it. Does anybody have one that could give me the specs for the capacitor?

Thanks
A capacitor is a capacitor. It doesn't have to be a Steel City part. Take the motor to a motor repair shop. They will know the right capacitor to fit that motor.
 

·
Registered
Joined
·
27,110 Posts
Did that they wanted $100 an hour to fit proper capacitor.
Dang, if I took a motor into my shop they would just look at the motor and go pull a capacitor off the shelf and only charge me for the capacitor as though I told them the model I needed.

The model 50250, is that the model of the motor or the saw? We could use the make and model of the motor.
 

·
Registered
Joined
·
3,283 Posts
just checking. how do you know it is a run cap? is there a start cap? how many wires are sticking out, 2?


is that a steel city name plate?
 

·
where's my table saw?
Joined
·
29,002 Posts
Cheaper than a new motor?

Probably cheaper than a new motor. While you were there, why didn't you just purchase the cap and wire in in yourself? It wouldn't take a hour to have them wire it, unless they have a $100 minimum, which is outrageous! JMO.
 

·
where's my table saw?
Joined
·
29,002 Posts
1 - 19 of 19 Posts
Top