[mark_anderson_us]

Hi Guys

Just ordered one of these and want to get some accessories ordered. Anyone know width and depth of miter slots (doesn't say in manual)?

Thanks

Mark

 

[mark_anderson_us]

Thanks

Do you happen to know the thickness of the riving knife? need to know if .125" kerf blade will work

Thanks

Mark

 

[mark_anderson_us]

I think it's .094 I've never seen a riving knife that wouldn't work with a .125 blade.

What blades are you looking at?

I was looking at this one: Forrest WW10407125 Woodworker II 10-Inch 40 Tooth ATB .125 Kerf Saw Blade with 5/8-Inch Arbor - Amazon.com

 

[mark_anderson_us]

If it were me....I'd buy a thin kerf glue line rip and a thin kerf ultimate cutoff, both by Freud and you'll have two specialty blades for less than the one WWII

Got this from SteelCity support

"The knife on the 35990 is thicker than 3/32. It's either 2.5mm or 3mm. (I can't remember off the top of my head)"

Not too helpful. Guess I'll have to wait until my saw arrives and get the calipers out.

Am considering one of these:

http://www.incrementaltools.com/Grip_Tite_Splitter_p/gtsplitterkit.htm

Anyone used one?

Thanks

Mark

 

[mark_anderson_us]

I don't think I believe that. I can't see them putting a riving knife on a 1.5 hp saw that won't allow for a thin kerf blade ....especially since their other saws are .094 inch knives.

Will wait for it to arrive. Shocked they don't know and can't be bothered to look/measure