Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi, this is my first time on this forum and im hoping someone out there can give me some advice. i have an old vanity w/mirror that i am refinishing. it has 3 separate tops, the middle section is 4" lower than the 2 sides. the problem is that it got some water damage at one time and the back 4" of each top has curled upward. i know how to steam bend wood, but my issue is that these tops have old bookmatched veneer on the tops and im afraid if i steam these boards that the veneer is going to come off. am i right? does anyone have any other suggestions on how to flatten the tops? thank you!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top