Woodworking Talk banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,524 Posts
I would make my cuts first, then stain the whole board, then highlight my cut marks in contrasting paint. Staining first would be OK but if you drag the router base or otherwise scratch the board while machining it, you would have to touch it up anyhow.
Good luck with your project! Show us some pics when you finish!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top