Woodworking Talk banner
1 - 1 of 1 Posts

· Old School
Joined
·
24,011 Posts

If you're sizing with a handheld saw, use the factory edge against the tablesaw fence. You might first run a block sander over the edge one pass to remove any debris.

Sizing panels can also ber done by using the size you want, and cut an oversized piece. Lay the oversized piece on the sized piece, clamp and run a flush trim router long the edges.






.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top