Woodworking Talk banner
1 - 3 of 3 Posts

·
Registered
Joined
·
189 Posts
Discussion Starter · #1 ·
I have a project i want to do inlay banding on, my front apron/top are over 36" long, I've read the term of splicing them using a scarf joint.

What angle is sufficient enough to hide these?
 

·
Old School
Joined
·
24,011 Posts
I have a project i want to do inlay banding on, my front apron/top are over 36" long, I've read the term of splicing them using a scarf joint.

What angle is sufficient enough to hide these?
The choice might depend on the pattern used. Some look seamless when scarfed, while others with perpendicular pattern look good with just a good butt joint.






.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top