Woodworking Talk banner
1 - 6 of 6 Posts

·
Registered
Joined
·
485 Posts
Discussion Starter · #1 ·
Porcelain Tableware Dishware Bowl Serveware

This was fun.
Jimmy
 

·
Pain in the A$$
Joined
·
1,904 Posts
Very nice designs. How were these made? Lathe? Some info would be GREATLY appreciated. Thanks.

Mark
 

·
Registered
Joined
·
485 Posts
Discussion Starter · #4 ·
I came across some 2-1/2" ply from a construction sight. Face(?)glued some pieces, made a few turns on the bandsaw to get them all round. Stuck them in the lathe and excepted whatever came out. I never know what it's going to look like till I'm finished.
 

·
Registered
Joined
·
485 Posts
Discussion Starter · #6 ·
Did you prep the plywood any before glueing it up?
Other than knock the mud off and apply the TB II, no other preps were done. Turned out OK, as far as I'm concerned. Mama likes it.
 
1 - 6 of 6 Posts
Top