Woodworking Talk banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I am wondering if there are a soft closing cabinet door hardware option in a scenario where the pre existing cabinets I think have a partial inset to them. I have attached a photo of the door. The frame has a facing on it and the gap between the edge of the door and inset are 3/8" as shown in photo. I've seen many options at home depot and other hardware stores for overlay and farmless but haven't found any hardware options I think will work for these cabinets. Any input would be appreciated as I am a newbie.
 

Attachments

·
Registered
Joined
·
1,742 Posts
Yep, those are good too, if you don't mind the extra hardware. And they totally win on cost, if you already have self closing hinges.

Looking at the OP's picture, we can't tell, but I'm assuming the doors have basic surface mount hinges, rather than self closing.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top