Woodworking Talk banner
1 - 6 of 6 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
I am in the market for a fairly small & inexpensive 4 head moulder, if such an item exists! There is a product I make out of standard 2x4 lumber (1-1/2"x3-1/2"). The final product is about 1-3/8"x2-3/4"x8-1/4". Now I run each piece through my planer twice, run each piece through the table saw twice, then cut everything to final length. Doing a few pieces like this is no big deal, but I normally do about 300 8 footers at a time! I figure a 4 head moulder would be a good option to bring the height & width to size in one shot. Everything I've run across so far is HUGE and in the $10,000+ range, which is out of the question. Any ideas? Thanks!
 

·
Registered
Joined
·
78 Posts
Discussion Starter · #4 ·
That's still more expensive than what would be practical for this item I am making. I was looking for something below $2,000. I could have sworn I saw one for about that about a year ago, but I can't find it now...
 

·
where's my table saw?
Joined
·
29,605 Posts
3 sided?

 
1 - 6 of 6 Posts
Top