[SeanStuart]

Hey, Simple question for you who are experienced:

I am going to cut a 9 foot board to frame a chess board. Standard 45* cuts.

I want the grain to match-up as much as possible. Do I cut the angle, then cut the opposite angle and move down the board, or cut the angle, then flip the board so the angle gives me the 90* when put together?

What is the most common way?

Thanks.

 

[SeanStuart]

That's about what I was thinking, but was curious if there was a "Correct" way to do this. Thanks.

 

[SeanStuart]

Thanks, not that critical, just trying to make it purty!

If the joints meet, maybe I'll post a photograph!