Woodworking Talk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
46 Posts
Discussion Starter #1
Hello everyone, I'm fairly new to the wood turning arena and have tried to turn a few pieces using the segmented parts but my cuts just are not accurate enough to look decent to me. Do any of you use a software program to give you an idea of the degree to cut your parts and what the finished product will look like after the work is done and if so what do you use? I saw a program on one website that looked like it would be what i would need but i can't remember where it was.
Thanks in advance,
Chad
 
1 - 3 of 3 Posts
Top