Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I want to make base moulding for a 12" diameter coloumn.
It will take 3 x 1-1/2 disc that I will glue up then cut to a circle.
I found router bits for the profiles I want, but I do not feel too sure of myself freehanding this disc on the table top, I will have to use a bearing because it's round? Any advice would be great!
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks for the reply, I will try it, concidering I got pricies of $650. for the trim. The post is 100 years old, I priced a replcment fiberglass coloum for $300.If I can do it myself I will be happy.
I don't think I can use a fence on the table because my piece will be round. I saw a bearing set with 4 different sizes, by starting with the big one and working down to the small one, I should be able to skim a little at a time?
Still I can't see how I can controll the disc from taking off, should I place a dowel on the bed someplace that I can pivit off of?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top