Woodworking Talk banner

Router Table Top Plans

1K views 14 replies 8 participants last post by  William H 
You dont need plans.
My table is simply two 3/4 inch pieces of MDF sandwiched together. I used contact cement to bond them.
Plastic laminate top and bottom and edge banded with 3/4 inch oak.
I used T-Track to mount the fence.
It's heavy, flat and has held up great for 20+ years with heavy use.
Simply make a template to cut the size of your insert.
Some do...
 
I'm not sure what th radius of the corners are but you can normally make a picture frame tight to the insert and using a flush bit with bearing(1/2) and it usually works pretty good.
Automotive lighting Audio equipment Liquid Gas Font
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top