Woodworking Talk banner
1 - 12 of 12 Posts

·
Senior Member
Joined
·
7,222 Posts
Nice looking bowls John. :thumbsup:

I will have to make a jig for my small router, it does enable a lot of possibilities for enhancements.
 

·
Registered
Joined
·
2,609 Posts
It helps that your bowls have a great form to begin with :yes:

I'm curious, how did you make the grooves contrast in the first one? (I can't tell if you glued in contrasting wood strips or if the groove is still open but "painted" black.)

Thanks!
 

·
Registered
Joined
·
3,257 Posts
Discussion Starter · #7 ·
I just painted the grooves by hand and then sanded off the paint that spilled over onto the top surface. Normally I would turn this paint off but I went to far and on the bowl before doing the routing and the wood moved slightly so re-turning was not an option.
 

·
Registered
Joined
·
1,048 Posts
Nice bowls.

Did you make a jig for your router to accomplish the routed grooves on all bowls? Did you route the bowls on the lathe of off?
 
1 - 12 of 12 Posts
Top