Woodworking Talk banner
1 - 2 of 2 Posts

· Registered
Joined
·
13,745 Posts
The table saw comes with a rip fence and is primarily designed to rip wood rather than cross cut it...hence the large number of "cross cut sleds" that have been designed and invented for them.

A sled makes no sense. :no: The longer the fence the more accurate and better will be the end result since there is more length to register against.

For ripping small pieces, just use your crosscut sled, and make a stop or support to register the small piece against.
Agree totally. When I read this "why" was also the first word that entered my mind.

George
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top