Woodworking Talk banner
1 - 9 of 9 Posts

·
Registered
Joined
·
336 Posts
Discussion Starter · #1 · (Edited)
I recently replaced the fence system on my circa 1995 Craftsman with an Incra fence system.
It was the top of the line TS in that era. Sold new for $800.
The model # 113.299112, contractor table saw, with hardware.
The fence itself is 2 1/2-3 inches wide, with micro adjust and has slots for attaching aux. sacrificial fence.
PM me if you are interested.

Selling fence system only.
$75.oo plus shipping. OBO.
 

·
Registered
Joined
·
336 Posts
Discussion Starter · #4 · (Edited)
Pics and measurements and more info to follow today.

Ok, the dimensions are.

Front rail. 70"
Rear rail 61"
Fence Length 36"
Fence width 2 1/2"










 

·
Registered
Joined
·
336 Posts
Discussion Starter · #7 ·
w1pers; Hi, I sent two replys to your message, check your message folder and see if they were received.

Thanks.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top