Woodworking Talk banner
1 - 8 of 8 Posts

·
Registered
Joined
·
239 Posts
Discussion Starter · #1 ·
I'm building some cabinet doors, similar to the below pic that I built about 3 years ago.....I plan to use birch ply for the panels....should I use 1/4", 1/2", or 3/4" for the panels...of course on the 1/2 or 3/4 I would rout the edges to fit the 1/4" groove.....the frames are being made from 3/4" clear pine.....my main concern is the weight of the panels....thanks for the help.....

 

·
Registered
Joined
·
239 Posts
Discussion Starter · #5 ·
Thanks for the link.....that was a very good read....would have never thought about gluing the ply panels to make the door stronger....thanks, again.....I'm off to the shop.....:yes:
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top