Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
602 Posts
I've purchased hardwood from a few different sources, and each has been a different experience. One particular yard that I liked quite a bit would measure the width (S2S, rough edges) and if it was 5-1/4", they'd call it a 1x6 & calculate board feet accordingly. I didn't care for that, but they were always generous with rounding down the length to allow for checks, damage, etc., on the ends, so it all evened out. And their bd ft prices were always reasonable.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top