Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
We have an old Power Shop Radial arm saw and I took the motor assembly out to check the bearings and also clean the tracks where the bearings go. Well that was months ago and when I tried to put the bearings back on the track it is very tight and I am unable to get it back in. So any help in this matter would be greatly appreciated.

Model # 500268-00
Serial # 64050684

Thanks
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top