Hey folks, I picked up this little drill attachment a while back and am considering making it a dedicated mortiser. I need to find a short stubby chuck (Jacobs), and a dedicated drill for it still.
I plan to use it for center located mortising by extending the arms and using using them on each side of the stock. All the mortising will be done with a forstner bit and cleaned up with a chisel.
![ForumRunner_20140213_181706.jpg]()
![ForumRunner_20140213_181725.jpg]()
I plan to use it for center located mortising by extending the arms and using using them on each side of the stock. All the mortising will be done with a forstner bit and cleaned up with a chisel.
