Woodworking Talk banner

1 - 8 of 8 Posts

·
Registered
Joined
·
314 Posts
Discussion Starter #4
I did use a router. And borrowed a scroll saw to cut out the numbers. Its not perfect bit not bad for a first time.
 

·
Maker of sawdust
Joined
·
460 Posts
Question for you when cutting out the numbers did you cut them out at a slight angle one or two degrees? If not in the future by doing so you end up with a fit that it you are slightly off can be pushed into place and then it's tight and all that you need to do is sand until flush. Nifty project

Jerry
 

·
Registered
Joined
·
13 Posts
gives me flashbacks of Jessie Pinkman's flashbacks...

(dont try to make sense of this if it doesnt come immediately lol)
 
1 - 8 of 8 Posts
Top