Woodworking Talk banner
1 - 4 of 4 Posts

· Registered
Joined
·
4 Posts
Discussion Starter · #1 · (Edited)
Plywood for glueing felt for outdoor poker table. What would be the best plywood for the job? This would be an insert that I could take out if needed. And would be covered if not taken out. I live in charleston SC , so it would get exposed to high humidity levels. As seen in the pic it's a small insert. I want a full insert for the table!

It is only going to be 25" x 70"
So how thick and best plywood to use, and if I should seal or not?
A plastic board would just cost too much!
Thanks for any help .
 

Attachments

· Registered
Joined
·
4 Posts
Discussion Starter · #6 ·
You would think that , but nobody has any! Not even my boat building buddy down the street @ Sea Island Boat Works,they have Starboard but its to much, but it would resolve all my problems, I may just shell out the money and be done.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top