Woodworking Talk banner
1 - 1 of 15 Posts

· Registered
588 Posts
I understand the reason for a minimum length but have you tried running one through yet? Not that I would suggest an unsafe act, :blink:, but I would probably try it at that length on my little Delta, in fact I have run 12" lengths through. You will have to be careful about snipe because that is a finished length with no room for error. Ideally, if you could make them longer to give a safer length, plus some excess for waste that could be trimmed off if your planer snipes it.

Just an idea, (?).
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.