Woodworking Talk banner
1 - 2 of 2 Posts

· Registered
Joined
·
36 Posts
Discussion Starter · #1 ·
I'm currently paneling the inside of my woodworking shed and trying to figure out hoe to best fit the paneling on the ends of my shed. The roof is of the barn type, so I'll be trying to get the correct angles at each point. Do I need to make some kind of template out of paper and doing it in sections or what, and how can I do this w/o damaging the paper while removing from the wall. Any of you gurus' out there have any suggestions?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top