Woodworking Talk banner

New fencing system

3K views 25 replies 11 participants last post by  retfr8flyr 
+1 for the incra, and the SE1000 miter gauge. I have had my incra fence for almost a year, and it is just great. The model I got for my 10 Craftsman is: INCRA TS-LS Table Saw Fence - 52"

I don't think you will be disappointed.

 
Yank, it may be the angle of the picture, but your rails look like they are almost centered on the table. Doesn't that keep you from making a 52" cut, defeating the purpose of the long rails?
I can't make a 52" cut anyway, the wall is in the way, I have been contemplating on repositioning my TS, to get more room, which means moving my jointer, outfeed table, and planer. Haven't had much luck in getting it done. That side of the shop is only 14' wide.

It is also not very often I have to cut something that long, if so, I use my skill saw and metal guide to resize the piece.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top