Woodworking Talk banner
1 - 4 of 4 Posts

·
Registered
Joined
·
803 Posts
Discussion Starter · #1 ·
The first one was that lil POS Delta....chucked it.
Should the outfeed table be flush with TDC or lower? FWW says some are .015" lower. Hmmmm....

Tips?

P.S. It's a 6" older BusyBee.
 

·
Registered
Joined
·
419 Posts
Jointer

Just wondering what you intend to use it for. The bed is rather short to be effective at flattening anything longer than 24". I had practically the same unit (Grizzly) and after months of trying to fool myself into thinking I couldn't get along without it, I sold it to some other unsuspecting woodworker apprentice for half of what it cost me. Now I invest my money in really good saw blades for the table saw and cut my glue lines rather than joint them.

Ed
 
1 - 4 of 4 Posts
Top