[BKBuilds]

First glue up attempt. Face gluing 2 pieces of oak that are about 5/8th thick.



Lots of squeeze out on all sides.

This will be cut down and will make one of the two rails for my cross cut sled.

Thoughts?

 

[bigcouger]

Looking good so far hope you didn't squeezed to much out tho can't really tell by the picture how did you do on line up

 

[TomC]

Nice set of clamps! Those should allow you to do many more glue ups.
Tom

 

[BKBuilds]

Thanks Tom!

BC, I wasn't really trying to line it up since its oversized in all aspects and will need to be milled down. But I think end to end it's pretty close.

 

[mengtian]

Nice clamps.....I thought that if you glue up two pieces of wood like that you have a chance of them bending eventually. If one board is affected by temp and/or humidity more than the other it puts stress on the other one.

 

[mdntrdr]

Nice clamps.....I thought that if you glue up two pieces of wood like that you have a chance of them bending eventually. If one board is affected by temp and/or humidity more than the other it puts stress on the other one.

Gluing two pieces together will make it more stable than a single piece of the same dimension. :smile:

 

[bigcouger]

Thanks Tom!

BC, I wasn't really trying to line it up since its oversized in all aspects and will need to be milled down. But I think end to end it's pretty close.

Good Job then :thumbsup::thumbsup::thumbsup: