[thegrgyle]

I did notice the 2 pieces. My biggest was how were ten angled cuts made? Also, how we're they spaced properly?

I'd really like to try and make one of these.

If you go to Kenbo and buggymans hummer build thread, in posts 379-380 (on page 19), you will see how Kenbo made his... I think to make the treads face opposite directions, you just adjust the miter gauge the other direction.

Hope this helps.

 

[thegrgyle]

I'd like to see the jig or the method for cutting the grooves uniformly deep and at the same precise angle.... I'm not coming up with anything simple myself. :no:

See post 14 of this thread