Woodworking Talk banner

1 - 2 of 2 Posts

·
Sawdust Creator
Joined
·
8,046 Posts
Discussion Starter · #1 ·
So I'm thinking of building a new crosscut sled, and I'm going to use an aluminum bar for the runner...and I was about to order a 30 inch bar when I said...wait, that seams really long.....

What length runners do you all have on your sleds?
 

·
Registered
Joined
·
353 Posts
The typical TS table is 27" wide. I usually make my runners about 14" long and make em out of Oak. I cut em just a bit undersized then use set 5 set screws



tapped into the edge to allow me to fine tune it to exactly fit the miter slot. Works Great!!!
 
1 - 2 of 2 Posts
Top