Woodworking Talk banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I have an oak stem that's been lying in its current position for four years (near London UK).

The stem measures as follows:
102cm Dia @ Above buttress flare
94cm Dia @ 1.5m
89cm Dia @ 3m
85cm Dia @ 5m
82cm Dia @ 7m

8.5m long (28')

I'm looking to mill using a Lucas Saw mill 8" cutting depth & width.
I'm looking for advice on best way to mill maximum planks and beams with a view to making a large table for clients outside eating area. Anybody have design & plans for making a table around 18-20' long?
 

Attachments

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top