Woodworking Talk banner
1 - 2 of 2 Posts

·
Registered
Joined
·
791 Posts
Discussion Starter · #1 ·
Got this last week in hopes of making some inlays fast and easy, I know its not the way I like to do woodwork... fast easy or cheap, but I tried. It might work fine for routing a V groove design. It falls seriously short on the inlay end. I am or was attempting to make something to dress up a corner. Seems the veneer when cut does not match the pocket.......the inserts when cut individually are too long to fit and I tried using the same spacing to cut the veneer and well you can see what the results were...
 

Attachments

1 - 2 of 2 Posts
Top