Woodworking Talk banner
1 - 1 of 2 Posts

· Registered
15 Posts
Discussion Starter · #1 ·
I want to practice on my Incra and thought I'd make some basic boxes to house an inwall rectangle speaker (until I get the time to fish and crawl in the attic :thumbdown: )

My question: If the box is to be say 5"x7" and I want to make 1/4" box joints, do I add 1/4" to the initial cut lengths of the sides? In my mind if I box jointed the 5x7 it would cut the inside area down the depth of the bit or joint right?
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.